Site Overlay


Worr Game Products Autococker Gun Manual · Worr Game Products Worr Machine Gun Manual · Worr Game Products Superstock Gun Diagram · Worr Game. Does anyone know where I can get/view the autococker sr manual?. Owners manuals for the Worr games Products (WGP) autocockers.

Author: Mojind Nataur
Country: Nepal
Language: English (Spanish)
Genre: Relationship
Published (Last): 16 November 2008
Pages: 486
PDF File Size: 18.23 Mb
ePub File Size: 18.55 Mb
ISBN: 575-9-43491-221-3
Downloads: 93097
Price: Free* [*Free Regsitration Required]
Uploader: Nicage

This mode gives the user fullautomatic with an unlimited rate of fire for a single pull, for use at the start of the game. The bolt should start to move back and re-cock the system. The marker will burst fire 3 times for every pull and release of the trigger.

This can be done manually.

Now, turn the regulator down to the point where the gun fires consistently and re-cocks. The manifold is gasket sealed with no hoses. Too high will lower max BPS and drain more power from your battery. Q What is timing? This SR Strip Kit is the perfect upgrade to ensure an effective and stylish marker. When safe and ready to fire, remove mannual cover and turn marker ON.

The range of adjustment is between 1 and 25ms. Empire Paintball Gear Bags and Packs. Pull the feed neck up and off of the feed port adaptor. Clean area with alcohol and reassemble. Low pressure from regulator. Lower the pressure a little and then take a couple of shots over the chronograph.

Autococker SR Manual

autocoker It will then boot into programming mode and display setting names and their current values. WGP offers barrel kit for adjustment with varying paint sizes. If you are attempting to fire the marker with out balls, the marker will feel slow. When it appears that it is only one shot, one pull for solid trigger pulls, try the slow pull test. Always keep your marker OFF and barrel cover on autococjer you are ready to fire.


Kanual will distribute the oil throughout the internals of the marker. Check ram housing gasket for cuts or tears. Valken Paintball Gear Bags and Packs. When the eyes are turned off, the max rate of fire is set to 25 balls per second. Fill bottle or adjust regulator. You may also have other rights which may vary from state to state. Replace or rebuild the ram.

Autococker SR Manual –

The cap is set by the max rate of fire setting. Mode 1 is normal semi-automatic with an unlimited rate of fire while the eyes are enabled. If set to 3rd pull, the mode will be active on the third shot after the marker is turned on.

It limits the maximum balls per second that can be fired. Break beam eyes blocked, check eyes. Never use anything other than. Eye cleaning and ball detent repair: There are many conditions that will affect velocity.

An additional test is to fire a few rounds quickly, then hold the autococksr right on the activation point to see if the marker will run away. It should be slow because there is a time that is setup in the program to allow a ball to drop into the breech.

Lubricate all moving parts with Vaseline, and reassemble. Reassemble the hammer and adjust you lug to the right position see Lug adjustment process. Attaching barrel and barrel sock g. In order to aktococker rate of fire you need to run the sear ON, loader delay, open delay, and close time as low as possible, without affecting velocity or blowback.


Sly Paintball Protection and Pads. Clean the eyes and examine the ball detents nubs Figure Aytococker To clean your marker you first find a safe environment then remove your loader, then fire all excess paintballs out of the marker. Put drops of paintball gun oil in the ASA, and shoot the gun until you can hold a paper towel over manul breach, shoot, and it stays clean. Treat every paintball marker as if it were loaded.

This feature is designed for quick and easy mainte-nance and upgradeability. Going up aautococker down in pressure can either increase or decrease your velocity.

Allow time to dry before use. Pull ram end cap with pump rod and shaft out carefully Figure The hammer will be held in by the lug and will not fall out. The front block manifold of the ASR has been completely redesigned. Carefully push the sear pin out form right to left Figure Allows the user to adjust the anti-mechanical bounce feature.

Use alcohol and a q-tip. Save the setting by pressing the middle of the scroll wheel.